360°
01
06

NCOP-SP03

Applying an
appropriate
amount

The Spray System can be installed very easily, as it does not require an I/O connection with the robots in use.
It helps to improve weld quality by applying an appropriate amount of spray.

NCOP-SP03

Spray System

Outline

We have developed a spatter deposition prevention spray system that is very easy to install, as it does not require an I/O connection with the robots in use.
The amount of spray can be adjusted with a valve, and further fine-tuning is possible by adjusting the the amount of time the nozzle is pressed down.
The excess liquid is collected, which keeps it from contaminating the workplace.
It contributes to improve weld quality by maintaining nozzles at a consistent quality at all times without stopping production lines.

Specification

Model
NCOP-SP03
Air pressure
5kg/cm²
Air hose diameter
Inside diameter of φ4 mm or more
Air hose
for sputter
Spray solution
Spatter Adhesion Preventive Agent
Weight
2.3kg
  1. 01

    To install it, the only input required is a pneumatic hose. Communication with the robots in use is unnecessary.

  2. 02

    The welding wire is retracted, and the nozzle is inserted into the holder.

  3. 03

    The nozzle is pressed down on the device, and it is sprayed with an anti-spatter liquid. Spray is evenly applied to the inside of the nozzle.

  4. 04

    The amount of spray can be adjusted to prevent the anti-spatter liquid from going to waste. The excess liquid can also be recovered and reused.

  5. 05

    The nozzle is pulled back up and spraying is complete.

OPTIONAL

NCOP-ST05

STAND

As the only input required during installation is a pneumatic hose, all products related to the Torch Cleaner can be set up on this stand. Its compact design takes up very little space.

©TIPMAN CO.,LTD